About 20-30% of a building’s heat loss occurs through its walls. The exact percentage for each house depends on its age, the materials used in construction and other factors. Even the most expensive heating devices will not help to heat such a house: unfortunately, they will only increase the amount of payment for utilities, and the heat, as gone, so will be gone. Only quality and competent insulation of walls can solve this problem.
After all, in essence, any wall (unless we are talking about modern frame houses, in the construction of which special attention is already given to the sealing of any part of the building) is not airtight, so even through the smallest cracks it lets warm air.
Materials for thermal insulation
Classic materials that have been used for many years as insulators: mineral wool, glass wool, basalt wool, Styrofoam, extruded polystyrene. Each of them, even against the background of good thermal insulation characteristics has many disadvantages that reduce their demand, and with the emergence of new, universal materials, and relevance.
One of these innovations in the field of energy saving houses is insulation for walls in the form of foam. It is economical to spray, and the effect is many times greater than the effect of already known and widely used materials.
How can it be insulated?
Specialists in the construction sphere distinguish two types of insulating treatment of the walls of the building;
- External;
- Internal wall insulation.
If we are talking about houses with hollow walls, it is still possible to use the third option: filling wall voids with insulation.
Before how to insulate the wall from the inside or outside, it should be taken into account that each of the methods, if they are applied separately, has its advantages and disadvantages.However, if you choose a universal and economical insulator, you can block all the ways of heat loss and seal the building as much as possible. Insulating foam Aisinin – a modern development of Canadian manufacturers, which is ideal for both external and internal work and is devoid of the disadvantages inherent in many insulation materials.Features of using the foamBefore you start external insulation of walls, it is necessary to install a frame, on which the facing material will be attached.After installing the frame on the wall is applied 10-centimeter layer of foam Aisinin. This thickness is enough for optimal thermal insulation of the wall.Then to the previously installed frame is attached cladding: siding or other types of facade panels.An important requirement for the treatment of walls ecopena: low-density asinine can not be covered with plaster!
Using this insulator for walls from the inside, it is also necessary to mount a frame for finishing materials, then apply foam. The surface of the walls must be leveled by cutting off the excess foam. In this case, OSB or gypsum board can be used as a facing.
Is it expensive?
Given the realities of our time, the main factor that the homeowner pays attention to when choosing insulation for the walls – the price. However, the approach to the issue of cost, unfortunately, is not always correct: trying to save on the price of insulation material, choosing the cheapest of those on the market, the consumer does not think about what will be the cost of the process of insulation. Ecopena Aisinin makes it cheaper due to economical consumption, no need for additional materials, maximum thermal insulation effect, which will very soon lead to a maximum reduction in energy consumption of the house.
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Sed in vulputate metus, vestibulum pharetra nisl. Vivamus varius quam ante, volutpat tempus ipsum commodo tincidunt. Nunc pellentesque ac ligula ut fringilla. Donec a justo sed arcu lacinia sagittis. Vestibulum iaculis risus non diam malesuada porttitor. Aliquam dui justo, blandit a elit eu, viverra pretium mauris. Nunc sed odio hendrerit, convallis mi ac, consectetur risus. Nam ut est eget tortor placerat malesuada. Nullam neque urna, tincidunt vitae tincidunt in, volutpat quis enim.
